MikroElektronika mikroProg Manuel d'utilisateur télécharger pdf (Page 12)

Page 13

Page 12

4. Connecting with a target device

For connection with a target device mikroProg

™

uses IDC10 JTAG connector, as shown on Figure 4-1. In order to make

proper connection with the target board it is necessary to pay attention to IDC10 connector pinout. Every pin has a

dierent purpose and for easy orientation IDC10 connector is marked with a little knob and incision between pins

number 9 and 7, Figure 5-1.

Figure 4-1:

IDC10 JTAG

connector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

MikroElektronika mikroProg Manuel d'utilisateur Page 12