MikroElektronika PIC Microcontrollers PIC16 Fiche technique télécharger pdf (Page 12)

Programming PIC Microcontrollers in BASIC - mikroElektronika

Note that the programming software should be used only for the communication with the

programming device — it is not suitable for code writing.

1.6 Running the program

For proper functioning of microcontroller, it is necessary to provide power supply,

oscillator, and a reset circuit. The supply can be set with the simple rectifier with Gretz

junction and LM7805 circuit as shown in the figure below.

Oscillator can be 4MHz crystal and either two 22pF capacitors or the ceramic resonator of

the same frequency (ceramic resonator already contains the mentioned capacitors, but unlike

oscillator has three termination instead of only two). The rate at which the microcontroller

operates, i.e. the speed at which the program runs, depends heavily on the oscillator

frequency. During the application development, the easiest thing to do is to use the internal

http://www.mikroelektronika.co.yu/english/product/books/picbasicbook/01.htm (8 sur 11)05/11/2004 02:10:07

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 193 194

Pas de commentaire

MikroElektronika PIC Microcontrollers PIC16 Fiche technique Page 12